PPG Editor

<< Click to Display Table of Contents >>

Navigation:  MILL Module > Post Processing Machining Operations  > Use Legacy Post > Dialogs >

PPG Editor

The VisualCAM Post-Processor Generator (PPG) Editor is shown below. This Editor is divided into sections (listed on the left) allowing you to define each block type. Refer to the list of sections below.

 

tog_minusDialog Box: Post Processor Generator: Editor
Dialog Box: Post Processor Generator: Editor

Dialog Box: Post Processor Generator: Editor
tog_minusPPG Editor Sections

•General  
This folder helps you set up file information, G-Code format, mode and the units of operation.

•Start End
Start and End code specifier.

•Tool Change  
Load and Tool Change Macro specifier.

•Setup  
Setup change and Rotate Table Setup specifier.

•Spindle  
Spindle code specifier.

•Feed Rate  
Feed Rate specifier.

•Motion  
Motion block specifier

•Circle  
Circle block specifier.

•Helical/Spiral  
Helical and Spiral motion block specifier.

•Multi Axis Motion  
Multi Axis Motion specifier.

•Cutter Compensation  
Motion blocks for Cutter Compensation Right, Left and Off.

•Cut Motion Start/End  
Cut Motion Start and End macro blocks.

•Cycles  
Cycle G-Code and format specifier.

•Miscellaneous  
Coolant and Compensation code specifier

•Variables  
Lists variables and their values used in post-processing
tog_minusRelated Topics

Introduction

Post Processor File Browser

Variable List Dialog