Macros

<< Click to Display Table of Contents >>

Navigation:  MILL Module > Post Processing Machining Operations  > Use Legacy Post > Macros >

Macros

The following is a list of the available macros in the VisualCAM Post-Processor generator.

StartEnd Tab

These macros are output before and after a tool path and therefore Runtime variables cannot be used.

Program Start up Code

Program End Code

 

 

Tool Change Tab

These macros are output only when a tool is loaded or changed.

First Load Tool Macro

Tool Change Macro

 

 

Cycles Tab

These macros are output only when the motion command is a cycle command.

Drill Code

Deep Code

Break Chip Code

Counter Sink Code

Tap Code

Bore [Drag] Code

Bore [No Drag[ Code

Bore [Manual] Code

Bore [Reverse] Code