The following Advanced Cut Parameters are similar for all TURN operations where the tab is available. Some parameters listed below may not be supported for every applicable operation. They allow smoothing of the toolpaths by introduction of arc motions.
|
You can use these parameters even if the controller does not support arcs. In this case, make sure that the output is set to
Turn Roughing Turn Finishing Groove Roughing Groove Finishing Turn Follow Curve Turn Threading Turn Parting Off |
 Advanced Cut Parameters tab, ALL TURN Operations |
Check this box to Perform Arc Fitting . The system will attempt to fit arcs along the computer toolpath if they lie within the three principal planes (XY Plane, XZ Plane or YZ Plane).  Tolerance (t) |